MA-600HII

• Main spindle motor, VAC 30/22 kW (10 min./cont.)
• Main spindle speed, max. 6,000 min-1
• Rapid traverse in X/Y/Z-axis; 60 m/min.
• Cutting feedrate in X/Y/Z-axis; Max. 60 m/min
• Table 1 degree indexing
• 40-tool ATC
• Tool pull stud bolt standard; MAS BT50 /MAS2 Through Pull stud
• ATC air blower
• Tool release lever (BT50)
• Spindle taper hole cleaning rod
• Hand tools
• Spindle cooling system
• Max acceleration in rapid traverse: 0.7G
• Spindle-through-coolant supply system, 15 kg/cm2
• Chip air blower, nozzle type
• Work light, Fluorescent light
• Internal chip conveyor
• Chip pan
• Two-layer signal tour (Blue; operation end lamp / Yellow; Alarm lamp)
• Foundation washers
• Totally enclosed guard
• 2-pallet swivel type APC (with two sets of MAS pallets)
• CE Mark and EMC
• IEC standard

OSP-P300M CNC Controller with 15" colour display, touch panel
OSP-P300M 3D-E kit specifications

• Auto program schedule update
• Work coordinate system selection, 100 sets
• Helical cutting function
• Synchronized tapping II
• Programmable travel limit
• Arbitrary angle chamfering
• 200 sets each of tool length offset and cutter radius compensation
• Tool life management function
• Auto power shutoff function
• Sequence stop
• 3D simulation function
• Interactive MAP function (I-MAP)
• Program storage capacity, 2GB in tape length
• Simple load monitor
• NC operation monitor
• TAS-S
• TAS-C

Electrical Power Source Application to suite local power source at each countries (CE transformer)

• All the specifications indicated in this specs are subject to change without prior notice.