MA-550V

• Main spindle motor VAC 22 / 15 /11 kW (10 min./ 30 min./ cont.)
• Spindle speed 10 - 6,000 min-1
• Spindle dia. ø100 , NT50
• Rapid traverse speed, X / Y-axis; 40 m/min., Z-axis; 30 m/min.
• Max. cutting feedrate, 30 m/min.
• Spindle cooling system
• Hydraulic power unit
• Hand tools (special tool only)
• Coolant supply system, 320 L tank 400 W pump motor
• ATC air blower (Air source to be prepared by end user)
• Chip air blower, nozzle type
• Work light, fluorescent lamp
• Screw conveyor 2 pcs , in front and at the back of table
• Chip pan
• Signal tower, 2-layer type signal lamp
• Foundation washers and leveling jack screws
• 32-tool ATC
• Totally enclosed chip & coolant shield
• Spindle-through-coolant system, 1.5Mpa BT50
• CE mark and EMC
• Application for IEC standard
• OSP-P300M CNC Controller with 15" colour display, touch panel
• OSP-P300M 3D-E kit specifications
• Auto program schedule update
• Work coordinate system selection, 100 sets
• Helical cutting function
• Synchronized tapping II
• Programmable travel limit
• Arbitrary angle chamfering
• 200 sets each of tool length offset and cutter radius compensation
• Tool life management function
• Auto power shutoff function
• Sequence stop
• 3D simulation function
• Interactive MAP function (I-MAP)
• Program storage capacity, 2GB in tape length
• Simple load monitor
• NC operation monitor

TAS-S
Electrical Power Source Application to suite local power source at each countries (CE transformer)

The specifications and descriptions in this Euro Standard are subject to change without notice.

Remark: TAS-C is not available.