MB-56VA
אלבה > מוצרים וספקים > ייצוג חברות > מכונות מבית OKUMA > מכונות כרסום > מכונות כרסום ורטיקאליות > סדרת MB-V > MB-56VA
With OSP- P300M
מכונת כרסום, מרכז עיבוד ורטיקאלי - תוצרת OKUMA
- Main spindle motor VAC 11/7.5kW (10 min./cont.)
- Main spindle NT40 (dia. 70mm)
- Main spindle speed, 50 - 8,000min-1, Max Torque: 198N-m
- Rapid traverse speed: 40m/min. in X / Y-axis and 32m/min. in Z-axis
- Cutting feedrate; max. 32m/min.
- Hydraulic power pack for the tool unclamping only
- Coolant supply system, 220L (Effective 120L) tank and 0.25kW pump motor
- ATC air blower
- ATC specification: MAS BT40 + JIS Special pull stud
- Chip air blower, nozzle type
- Screw type chip conveyor, 0.1kw x 2pcs
- Chip pan
- Status indicator lamp, 2-layer type (Blue: Operation end lamp / Yellow: Alarm lamp)
- Foundation washers
- 20-tool ATC
- Totally enclosed guard (CE mark application)
- Through-the-spindle coolant supply system, middle pressure 1.5MPA / 12L/min / BT40(Pulstud bolt std.: JIS)
- Remark: After #0022 machines,above spec are standard. But until #0021 machines are 1.5MPA/12L/min .
- Pre-arrange for Lift-up chip conveyor floor type (incl. Harting socket for Mayfran & standard chip pan) Pre-arrange Chip Conveyor M-A type
- Remark: After Feb/02 prod machines,above spec are standard. But until Jan/02 prod machines are not including any Harting socket & I/F.
- Spindle head cooling with oil controller
- CE-mark / EMC
- IEC regulation
- Auto program schedule update
- Work coordinate system selection, 100 sets
- Helical cutting function
- Synchronized tapping II
- Programmable travel limit
- Arbitrary angle chamfering
- 200 sets each of tool length offset and cutter radius compensation
- Tool life management function
- Auto power shutoff function
- Sequence stop
- 3D simulation function
- Interactive MAP function (I-MAP)
- Program storage capacity, 2GB in tape length
- Simple load monitor
- NC operation monitor
- TAS-S
TAS-C
Electrical Power Source Application to suite local power source at each countries (CE transformer)
The specifications and descriptions in this Euro Standard are subject to change without notice.
Electrical Power Source Application to suite local power source at each countries (CE transformer)
The specifications and descriptions in this Euro Standard are subject to change without notice.
| Max Machining Volume | mm | 1,050x560x460 |
| Table Size | mm | 560x1,300 |
| Spindle Speed | min⁻¹ | 50-8,000 |
| Spindle Motor Power - Low Range | kW (hp) | 11 (15), 26 (34.7) |
| Spindle Motor Power - High Range | kW (hp) | 7.5 (10), 18.5 (24.7) |
| Rapid Traverse | mm | 40 / 32 |
| Magazine Capacity | MB-56: 20 [opt. 32, 48] | |
| Machine Weight | Kg | 7,300 |
